D-Links Links selector for all vehicles

  • $0.00


This calculator will help you pick the perfect setup for your RC crawlers.  Simply follow through the drop downs choosing the options you need.

Delrin (1/4") is the lightest and slides the best over rocks, logs, and other trail debris.
Aluminum (1/4") is slightly heavier then delrin and does not slide as well, but is less likely to flex over time.
Brass (1/4") is the heavy weight, typically used as lower links for good vehicle balance.  It typically slides better then aluminum.
Chubbies (5/15") is the big daddy for weight.  It's made of brass rod and is very stout.  This is great for that massive down low weight that crawlers often need to stay planted to the ground.

High Clearance Option:
The high clearance option gives you a bend on the rear lower links to help clear obstacles.  You may find on certain vehicles this will leave your drive shaft more exposed to damage.  Some folks will put spacers between the link and rod end to achieve to clock the driveshaft upwards out of the way. 

*warning* the scx10 can not use high clearance unless you install upper link relocation brackets first. 

Rod Ends:
If you choose to use stock rod ends your links will be tapped to whatever the manufacture spec was.

Traxxas rod ends and Boom Racing rod ends are a 4mm tap (standard).

Steering:
Steering tie rod and drag links are available for an extra charge, but due to so many different options for knuckles and steering, you must include your desired link length, measured eye to eye or screw hole to screw hole. We can not be held responsible for incorrect fitment, but we will work with you to get the correct fitment should there be an issue.

Extras:
Custom sizes available on request. Just measure center of eyelet to center of eyelet and enter in the box.

Warranty Info:
D-Links are made in the U.S.A.  All D-Links are lifetime guaranteed.  Send in the broken link and receive a brand new one.  We can not guarantee the rod ends as they are a wear item and very between brands.

Available for the following crawlers:
Axial SCX10 all models

Axial SCX10ii all models
Axial Wraith all models - wraith links have bends already to clear the driveshafts
Axial SMT
HPI Venture - rear upper links require you to install the 4 link bracket.
Vaterra Ascender All Models
Traxxas TRX-4 all models - trx-4 owners should reuse the trx rod ends as they have special bends in the them to line up correctly.
RedCat Gen7
RedCat Gen8
GMade Komodo
Losi Night Crawler